Download the latest Device Connectivity Optimization Tool for Tecno, Infinix, and Itel devices. This utility is designed to assist in restoring signal communication, baseband configuration, and firmware-related partitions such as system calibration, modem settings, and data integrity for smartphones powered by MediaTek, Qualcomm, and SPD chipsets.
In this step-by-step guide, you'll learn how to download, install, and effectively use this signal recovery tool. The guide also covers installation of the After Sales Utility Suite, MTK USB drivers, and the ConfigPlus Interface Tool. Follow all steps carefully to ensure a safe and successful restoration process.
| The Device Connectivity Utility is a powerful diagnostic software used to restore mobile communication modules such as baseband identity, signal partitions, calibration zones, and system configuration files. Start by downloading the utility to your PC and extracting it with WinRAR or 7-Zip. This toolkit is essential for fixing software-related communication failures. |
How to Restore Signal Profile on MediaTek (MTK) Chipset Devices
Disclaimer: Modification of network-related identifiers may be regulated in your region. Always use the original information supplied with your device (found on the phone's label or box).
Steps to restore the connectivity profile of your device:
- Install the required MTK USB drivers, ConfigPlus Interface Tool, and After Sales Utility Suite. Extract using 7-Zip or WinRAR.
- Launch the After Sales Utility Tool (version 1.5.1).
- Select "Connect" inside the tool interface.
- Power off your mobile and connect it via USB to your PC.
- Check that the MTK port appears in Device Manager and that Meta Mode activates on the screen.
- Disconnect the device and exit the After Sales Tool through Task Manager.
- Launch the ConfigPlus Interface Tool and click "More" under Platform.
- Click on "Connect" and then reconnect the phone to your PC.
- Verify all stages (Boot, Kernel Port, AP Connection, etc.) pass successfully, then click "Load DP".
- When prompted, select "Load from Target".
- Navigate to the Network Profile section and open the signal configuration tab.
- Enter the device's original configuration values from its label.
- Click on "Write" to apply the settings and restore communication capabilities.
- Close the interface and safely disconnect your device.
Download Tools & Config Files for Signal Restoration
| Download Link (Mediafire) |
| Download Link (Mediafire) |
| Download Link (Mediafire) |