Tecno Pop 8 BG6i Stock ROM | Flash File Firmware (Pac File)

📱 Tecno Pop 8 BG6i Stock ROM | PAC Firmware Flash Guide (IMEI Boot Repair)

⚠️ IMPORTANT: This guide is for educational purposes only. We don't provide direct firmware downloads. Obtain official BG6i PAC files from Tecno Mobile authorized sources.

🔍 BG6i Firmware Details

Device Model
Tecno Pop 8 (BG6i)

Chipset
UniSoC T606

Android Version
Android 13 (Go Edition)

📋 Pre-Flash Checklist

• ✅ Confirm BG6i model (under battery or Settings → About Phone)
• ✅ 80%+ battery (critical for successful flashing)
• ✅ SPD Research Tool v5.2024+ (latest version)
• ✅ Spreadtrum USB Drivers v3.3 (properly installed)
• ✅ High-quality USB cable (tested for data transfer)
• ✅ Backup NV data (IMEI preservation)

⚡ Step-by-Step Flashing Process

1. Software Preparation:
Disable driver signature enforcement → Extract BG6i PAC file → Install SPD Tool as Administrator

2. Enter Download Mode:
Power off → Hold Volume Down + Power for 10 seconds → Connect USB cable

3. Configure Flash Tool:
Select "Firmware Upgrade" mode → Load BG6i.pac file → Set baud rate to 1,500,000

4. Start Flashing:
Click "Download" button → DO NOT DISCONNECT (process takes 25-40 minutes)

5. First Boot:
After "Download OK" message → Disconnect → Force restart (hold Power 20 seconds)

🔐 Professional IMEI Repair Method

1. After successful flash, dial *#*#3646633#*#* to access Engineer Mode
2. Navigate to Connectivity → CDS Information → Radio → Phone
3. Enter AT command: AT+EGMR=1,7,"YOUR_IMEI" (replace with original IMEI)
4. For dual SIM devices: AT+EGMR=1,10,"IMEI_2"
5. Save changes → Reboot device → Verify IMEI with *#06#

⚙️ Dead Boot Hang on Logo Solutions

Issue	Solution
No power response	Charge for 4+ hours → Try test point method
Stuck on Tecno logo	Reflash with "Format All + Download" option
Continuous boot loop	Flash boot.img separately via fastboot
No network signal	Flash modem.img and nvram.img

💡 Expert Tip: For persistent dead boot issues, remove battery (if possible) before using SPD Tool's "Force Download" mode.

✅ Post-Flash Verification

• 🔍 Verify IMEI numbers (*#06#)
• 📶 Test all network bands (2G/3G/4G)
• 📷 Check camera and sensor functionality
• 🔋 Monitor battery performance for 3 full cycles
• 🔄 Check for available OTA updates

📢 LEGAL DISCLAIMER: Tecno Pop 8 BG6i firmware is proprietary software. IMEI modification may violate local laws in some regions. Only restore original IMEI numbers. We don't host or distribute copyrighted material.

Download the necessary tools and drivers:

SPD USB Drivers SPD Upgrade Tool Transsion Tool

ROM Tecno Pop 8 BG6i OP V152 240103

© Firmware4mobile