Download Tecno Spark Go 2024 BG6M Flash Firmware | Official Stock ROM for Boot Repair

ℹ️ NOTE: This guide explains the official flashing process. We do not provide direct download links to copyrighted firmware files.

🔍 BG6M Firmware Details

Device Model
Spark Go 2024 (BG6M)

Chipset
UniSoC SC9863A

Android Version
Android 13 (Go Edition)

📋 Preparation Checklist

• 🔋 50%+ battery (minimum requirement)
• 💾 Backup all data (contacts, messages, media)
• 🖥️ Windows 10/11 PC (admin privileges required)
• 📌 Original USB cable (data transfer capable)
• ⚙️ SPD Flash Tool v5.1820+
• 💿 Spreadtrum USB Drivers

⚡ Flashing Procedure

1. Software Setup:
Install SPD drivers → Extract BG6M firmware package → Open SPD Research Tool

2. Configure Flash Tool:
Select "Firmware Upgrade" → Load BG6M.pac file

3. Enter Download Mode:
Power off device → Hold Volume Down + Power → Connect USB

4. Start Flashing:
Click "Download" → Wait 15-25 minutes (progress bar completes)

5. First Boot:
Disconnect → Power on → Initial setup takes 5-8 minutes

🔧 Common Issues Fixed

Issue	Solution
Boot loop	Full firmware flash
Hang on logo	Format + Download
Network issues	Flash modem partition
Touch problems	Replace touch driver

💡 Pro Tip: After successful flash, perform factory reset from recovery mode for best performance.

✅ Post-Flash Verification

• 🔍 Check IMEI (*#06#)
• 📶 Test network connections
• 🔄 Verify all sensors
• 🔋 Monitor battery life

📢 LEGAL: Tecno Spark Go 2024 firmware is proprietary software. Obtain files only through official channels.

Download the necessary tools and drivers:

MTK USB Drivers SP Flash Tool (with Auth Bypass) DA Auth File SP Flash Tool V5 1824

ROM Spark_Go_2024_BG6M_RU_V136_SPD