Tecno Spark Power 2 LC8 Firmware Stock ROM | Fully Verified File by Mobile Technicians

MR MOBILE
0

If your Tecno Spark Power 2 LC8 is stuck at boot logo or misbehaving due to corrupted software, this official firmware can rescue it instantly. šŸ› ️ Whether it’s a soft brick or a firmware loop, flashing the original stock ROM will make your device run like new again. šŸ†•

šŸ“¦ Firmware Package Info

  • Model: Tecno Spark Power 2 (LC8)
  • Processor: MediaTek Helio P22 (MT6762V)
  • Android Version: Android 10 (HiOS)
  • File Format: Scatter File (.txt) + System IMG
  • Status: Clean, Verified & Factory Stock šŸ”’

šŸ› ️ Fixes the Following Problems

  • šŸ”„ Bootloop or stuck on Tecno logo screen
  • šŸ’€ Device not turning on after failed update
  • šŸ“¶ Baseband or IMEI not detected
  • šŸ”‹ Charging-related software bugs
  • šŸŒ€ Phone stuck in recovery or fastboot

šŸ”§ How to Flash the Tecno LC8 Firmware

  1. Install MediaTek USB drivers on your computer
  2. Download and extract SP Flash Tool
  3. Open the tool and load the MT6762_Android_scatter.txt file
  4. Connect the powered-off phone via USB while holding Volume Up
  5. Click “Download” and wait for green success tick ✅

⚠️ Safety Guidelines Before You Flash

  • šŸ”‹ Charge your battery to at least 50% or more
  • šŸ’¾ Take full backup of your phone — flashing will erase all internal data
  • ✅ Ensure model LC8 matches exactly to avoid misflash

Post a Comment

0 Comments

Please Select Embedded Mode To show the Comment System.*

#buttons=(Ok, Go it!) #days=(20)

Our website uses cookies to enhance your experience. Check Now
Ok, Go it!